Jetzt outen sich alle - der Reihe nach.
Somit auch ich

Hab mich auch überzeugen lassenSteinscheißer Karl hat geschrieben: ↑Do 9. Jan 2020, 16:37Hihi,
Jetzt outen sich alle - der Reihe nach.
Somit auch ich- dem simultan seinen Handguard hab ich auch gestern bestellt. Melde mich in 19-35 Tagen. Oda so...
Sehr sympathisch!
https://www.recoilweb.com/the-rifle-tha ... 55055.htmlWhen the handguard arrived, it actually looked pretty decent. Not only was it lacking that chalkboard-made-in-China feel, it had anti-rotational tabs, a barrel nut made of steel, and a whopping five quick-detach sling points. If you put it on a shelf in a gun shop, no one would believe it only cost $27. Ultimately, it ended up being LG;FU. That is to say: Looks Good; F*cked Up.
None of the QD points were in-spec; all were undersized. When the barrel nut was properly aligned to allow the gas tube to enter the upper receiver, the rail was canted several degrees. We had to shave down the alignment tabs to line up the rail with the upper. The handguard itself was a study in poor aluminum extrusion; rather than remaining in-line with the upper from tip to tail, it nearly touched the barrel at the muzzle end.
Off-topic, aber nach 10 Jahren/Generationen iPhones war meine Geduld einfach am Ende.
Bestell du mal und dann wart ich auf dein ReviewCoolhand1980 hat geschrieben: ↑Di 14. Jan 2020, 10:30Bei der Frage schließ ich mich an...Mich tät der CTR interessieren. Nur ob Mil Spec oder Commercial steht da nirgends dabei.
Ob das wohl in der chinesichen Toleranz liegt?![]()
Der Handguard ist heute (!) angekommen. Sieht gut aus, greift sich gut an. Leider hab ich es noch immer nicht geschafft, meinen LP Gasblock von einem Schützenkollegen abzuholen, daher muss ich noch warten, bis ich ihn montieren kann.Steinscheißer Karl hat geschrieben: ↑Do 9. Jan 2020, 16:37Hihi,
Jetzt outen sich alle - der Reihe nach.
Somit auch ich- dem simultan seinen Handguard hab ich auch gestern bestellt. Melde mich in 19-35 Tagen. Oda so...